Fog Cleanroom Generator

China Fog Cleanroom Generator Supplier

FG-10 Fog Cleanroom Generator is economical and practical type pure water fogger.It uses ultrasonic atomization principle,atomizing pure water into a lot of mist around 1-10 microns.Under extemal pressure,it is piped out through smoke exhaust pipe,it can exhibit thick smoke,it is very intuitve to visualize the airflow state in a number of industries,especially in the clean room industry.

Cautions

·Keep the water tank clean.

·Please ensure that the added liquid is purified water.Otherwise it will affect the use life of the product.It is strictly forbidden to addoily media.

·Make sure the power supply is at the correct rated voltage before use.

·The chassis should be placed horizontally and should not be tilted or flipped.

·After use,turn off the power or unplug the plug and drain the remaining pure water.

·The amount of water should be added to the red line.Too much or too little water will affect the concentration of fog.

·The control circuit board should not be in contact with water to prevent short circuit

·Pay attention that the fan can not touch the water to prevent short circuit

·The water temperature in the water tank should not be higher than 50'C.Avoid placing the fogger beside the electronic equipment to prevent the electrical equipment be damaged by the water mist.

·Please leave it in a dry place after use.

It is used for laminar flow test in clean room and pressure balance test inside and outside the room. Chemical treatment equipment exhaust system test,air duct leakage test,etc.

Sorry  There is no "Video", you can view other services.